Taking loads tonight

Added: Tawnia Caplinger - Date: 24.12.2021 18:11 - Views: 37115 - Clicks: 3781

The winter demand shows a rapid increase in electricity usage of approximately MWpredominantly due to increased use of space heating, geysers, pool pumps and cooking appliances. The electricity demand reaches a maximum during the evening, which is referred to as the evening peak between 5pm to 9pm. The greatest increase and risk period of load shedding in winter is between pm to pm. The winter demand shows a rapid increase in electricity usage of approximately MW, predominantly due to increased use of space heating, geysers, pool pumps and cooking appliances.

To maintain supply capacity when faced with winter demand, Eskom has adjusted its maintenance schedule so that additional capacity becomes available in winter by doing less maintenance in this period. However, scheduled maintenance must continue to be pursued for long-term plant health. Every year, the high level of illegal connections causes ificant load increase and subsequent overloading of localised networks.

To counter illegal connections and prevent meter tampering, Eskom has embarked on an intense national partnership programme called Operation Khanyisa. Operation Khanyisa promotes the legal, safe and efficient use of electricity in South Africa. This national partnership campaign has various stakeholders, including Business; Eskom; Government; Civil Society; the Media; and ordinary South Africans. You can help sustain the capacity of our national energy grid by preventing, detecting and reporting electricity theft.

Be an Operation Khanyisa ambassador. On the Supply side, Eskom also purchases power from cross-border countries, mostly Mozambique, local independent power producers, and from municipal generation to increase supply capacity and reduce the use of expensive Open-cycle Gas Turbine generation. But despite these measures to balance supply and demand, our national electricity system continues to remain tight and vulnerable, meaning that any shift on the power system could result in a shortage of supply. As this occurs at night, residential customers have the power to make the biggest difference.

South Africa has a flat profile or Table Mountain profile in summer, which means that Demand is high for the entire day, until 9pm, predominantly due to the increased usage of air-conditioners, geysers and pool pumps. In addition, planned generation maintenance increases ificantly in summer, and we have less capacity to supply demand. This means that the risk of load shedding remains high throughout the day in summer until 10pm; and in the event of unplanned activities within the electricity supply chain.

The stable supply of electricity is affected by many variables which can impact on our capacity to supply. They include, but are not limited to, extreme weather conditions, issues on our transmission lines, quality and availability of raw materials or primary energy such as coal, water, wind, solar as well as unforeseen faults from Cahora Bassa imports from Mozambique, and unplanned failure on our plant such as, fire damage or mechanical problems.

naughty floozy Madisyn

In the event of ificant incidents on the power system, the probability of load shedding increases, but it remains impossible to predict accurately when we will have to reduce load. Wet coal is one of the variables which can impact on our capacity to supply.

sexual wives Sariyah

But persistent wet-weather conditions can cause supply challenges that impact on available capacity. The collieries which supply Eskom are contractually obliged to ensure that their coal meets quality requirements including coal size, its moisture content, abrasiveness and combustibility. The coal on the strategic stockpile is mainly coarse material which does not easily absorb moisture.

Coal is fed from the stockpiles to storage bunkers at the power station on conveyor belts and from there is fed into pulverising mills which grind it into dust as fine as cake flour. Hot air, to dry it, blasts the powdered coal through coal burners to the boiler furnace where it burns like a gas — and the heat from the burning coal causes demineralised water contained in tubes to convert to steam at high temperature and pressure.

This superheated steam passes to the turbines where it expands and releases its energy causing the turbines to spin — and generate electricity. Though coal normally contains both inherent as well as surface moisture, it is clear that excessively wet coal has a limiting effect on the effective generation of electricity. It can become a muddy sludge that creates blockages at transfer chutes which shift coal from one conveyor to another — and the excessive weight of wet coal can cause conveyors to break.

Wet pulverized coal can also cause clogging of milling plants and associated pipe works, which le to mills being shut down to be cleared by hand, meaning boilers cannot receive fuel so must be shut down too. Eskom is dealing with the wet coal challenge and doing all it can to prevent stops in the future, including more effective stockpile management, ensuring adequate availability of coarse coal for excessively wet conditions, researching and improving the operations of boilers, and researching the properties of coal itself, to ensure that coal supplied by collieries is up to the standards required.

Transmission problems can impact on our capacity to supply electricity due to the following variables:. To understand how planned maintenance can impact on our capacity to supply, think of a power plant as a motor vehicle like a car or a truck If we do, this could have serious consequences which could place the entire grid at risk. But power plants cannot be taken to the mechanic. Our engineers must go to the power plants and, due to the sheer size and of the parts; it takes quite a long time for the full maintenance to be completed.

This means we have many units offline during the year, with a greater percentage in summer and as a result have less generating capacity, and cannot supply as much as we do during winter. When the power goes off, it is sometimes difficult for a customer to know whether the cause is load shedding, or another reason. There are three basic reasons why the power could go off — Faults on the networks, Planned Maintenance of the networks, and Load Shedding.

From an Eskom perspective, all are managed differently, but the impact on the customers is similar — the power goes off. The main difference is that when a network fault occurs, it is unplanned and unexpected. Eskom has to respond to the event, either after reports from customers, or where our telecontrol systems tell us that the power has gone off.

Planned maintenance of the networks, as the name implies, is planned and prearranged, and customers are notified in advance when their supplies will be disrupted so that we can perform maintenance. The impact on customers is isolated to the specific area or network where the work is to be done. Planned outages vary in duration, depending on the amount of work to be done. By contrast, load shedding impacts all customers in rotation, according to a plan the schedule and for a consistent period of time.

In Eskom we need to manage all three processes, i. If you are scheduled for a load shedding period when the power goes off, you can reasonably assume that the reason is indeed load shedding. However, if the power outage persists for longer than the published switch-on time, it should be treated as a fault and reported. Eskom or your municipality will then investigate as soon as possible, so that you would not have the unnecessary delay if you waited for several hours and only then called to report the fault. Customers are strongly advised always to check the load shedding schedules, and any outage that does not coincide with these MUST be reported as a fault.

Do NOT assume that it is load shedding if the power is off and the schedule does not say that it should be. Eskom staff and municipal staff must ALWAYS assume it is a fault unless it coincides with the published load shedding schedules, or with a notified planned outage.

The following will not be available when the electricity supply to your home is switched off: Electric geyser and electrically heated water supplies Gas hot water systems that rely on mains power to control the system or ignite the gas Electric appliances such as stoves, kettles, toasters, microwave ovens, refrigerators, dish washers, washing machines and tumble dryers Electric lights TV and hi-fi equipment Cordless phones, fax machines and answering machines that run on electricity Electrically motorised security gates and garage doors those with battery backup should have sufficient capacity to operate a few times during load shedding Pool pumps Personal computers Electric air conditioning Mains powered electric clocks and alarm clocks without backup batteries Household electric pumps for water features, irrigation or plumbing systems Automatic electronic control systems and time clocks.

What will usually not be affected by power outages? Security systems that have battery backup some may trigger an alarm because of the power interruption Other electronic systems and devices with battery backup or UPS support Landline Telephones that do not rely on mains electricity Cell phones provided they are charged Laptops and tablets provided they are charged Battery operated toys and appliances. Keep aware of the state of the power system and whether the country is likely to load shed, or if it is load shedding, and if so, in what stage.

Think about transport: ensure that your vehicle always has fuel in the tank because many petrol stations cannot pump fuel during power outages. Think about cash: ensure that you have enough cash because ATMs cannot operate without electricity.

Think about access, security and safety: Make sure that the backup batteries in your electrically operated gates, garage doors and security systems are in good condition to last through periods of load shedding. Keep temporary lighting readily available, e.

ebony girls Claire

Make sure you put these items in places where they will be easy to find in the dark. Modern LED lamps and torches are recommended as they are bright, long lasting and avoid the fire hazard of gas lamps and candles.

Keep battery-operated equipment charged e. Think about keeping things cool and heating them up: Boil water and keep it in thermos flasks for hot drinks for times when the power is scheduled to be switched off. Use an insulating cover on teapots and other pots and pans to keep drinks hot, and meals warm. Prepare meals beforehand in readiness for periods when there will be power cuts.

Obtain a small stand-by bottled LP gas heating ring for essential cooking and to boil water for hot beverages. Keep adequate stocks of essential foodstuffs. Keep refrigerator and freezer doors closed. A power outage lasting four hours should not cause food spoilage, and a freezer should keep frozen food safe for at least a day. It is a good idea to have alternative snacks available that do not need refrigeration. Most medication requiring refrigeration can be kept in a closed fridge for several hours without spoiling.

To be sure about this, check with your doctor or pharmacist.

Tonight’s the night for HILARIOUS variety act Ben Langley! - Auditions - BGT 2018

Fill plastic containers with water still leaving some space inside each container for expansion during freezing in a deep freeze or the freezer compartment of your fridge. This frozen bottled water will help keep food cold during a power outage. If circumstances dictate that you cannot be without power even during periods of load shedding, you may want to consider investing in a petrol, diesel or gas-powered generator, or a UPS system deed to power those pieces of equipment and appliances that you consider essential.

Can load shedding damage my appliances? What should I do to prevent this? If the power goes off, it is safer to turn off or even better, disconnect any electrical appliances that you were using. Keep one light switched on so that you can see when the power returns. When the power comes back on, it may do so with a momentary surge, which may damage electronically controlled appliances such as computers, television sets, VCRs, DVDs, etc.

Remember to reset the time-control clocks on cooking ovens, pool pumps, geysers and other automatically controlled appliances, unless these are battery operated. Also remember that householders are responsible for all electricity usage and appliances in their homes. What precautions should I take in case load shedding happens while I am away? Switch off and disconnect all non-essential appliances such as computers, coffee machines, television sets and entertainment consoles.

Switch off your geyser while away so that you avoid the cost of heating water unnecessarily. Remember to switch it on as soon as you return, install a geyser timer or ask a neighbour to switch it on for you a few hours before you get home. Leave appropriate lights on for security purposes preferably operated on timers, not left on all day and night.

Metallica: Enter Sandman (Official Music Video)

Replace conventional outdoor lights with motion sensor lamps for security. They use less electricity because they only activate when the sensor is triggered. Make sure that the backup batteries in your electrically operated gates, garage doors and security systems alarms and electric fences are in good condition. Fix leaky taps. Allowing water, especially hot water, to drip down the drain wastes both water and electricity.

Set your pool pump to operate for a maximum of four hours a day, which is ample to keep the pool clean while it is not being used. Make sure your pool pump is set so that it does not operate in the period from 5 to 9 pm, which is when the peak electricity demand for South Africa occurs. Leave a key with neighbours and ask them to check your property regularly, and to make sure that the main switch or earth leakage have not tripped i. Customers with special needs, such as medical support equipment ventilators, dialysis machines, etc. For example, it may be possible to obtain a battery backup unit for medical equipment, or to get additional oxygen cylinders as a backup.

It is generally impossible to leave the power on for individual customers when whole networks and areas are switched off, so customers with medical needs must please take extra precautions to ensure that their needs are provided for, and that they are adequately prepared to deal with power cuts. Infographics for Lohedding Managing demand in winter — What Eskom does? Managing demand in winter — What you can do? Managing demand in summer — What you can do? What are the impacts on supply capacity?

Taking loads tonight

email: [email protected] - phone:(486) 618-1837 x 1419